Dell XPS 600 - Manual (Page 93)

Removing and Installing Parts
93
6 Gently pull the securing tab (if present) and place the card in the connector. Press down
firmly and ensure that the card is fully seated in the slot.
If the card is full-length, insert the end of the card into the card guide bracket as you lower the
card toward its connector on the system board. Insert the card firmly into the card connector
on the system board.
7 Before you lower the retention arm, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
the computer cover from closing properly or cause damage to the equipment.
8 Press the retention arm into place, securing the card(s) in the computer.
fully seated card
not fully seated card
bracket caught
outside of slot
bracket within
slot
alignment guide
alignment bar