Dell POWEREDGE M1000E - Manual (Page 138)

120 Dell Converged Enhanced Ethernet Administrator’s Guide
53-1002116-01
Configuring ingress Port Mirroring
13
Configuring ingress Port Mirroring
To configure Port Mirroring for incoming packets only, perform the following steps in global
configuration mode.
1. Open a monitor session and assign a session number
switch(config)# monitor session 1
2. Configure the source port and the destination port, with the rx parameter for received packets.
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction rx
3. Optional: Use the description command to add a label to the monitor session.
switch(config-mon-sess-1)#description Hello World!
4. Repeat step 1 and step 2 as needed for additional ports.
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
Configuring egress Port Mirroring
To configure Port Mirroring for incoming packets only, perform the following steps in global
configuration mode.
1. Open a monitor session and assign a session number
switch(config)# monitor session 1
2. Configure the source port and the destination port, with the tx parameter for transmitted
packets.
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction tx
3. Optional: Use the description command to add a label to the monitor session.
switch(config-mon-sess-1)#description Hello World!
4. Repeat step 1 and step 2 as needed for additional ports.
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
Configuring bidirectional Port Mirroring
To configure Port Mirroring for packets traveling in both directions, perform the following steps in
global configuration mode.
1. Open a monitor session and assign a session number
switch(config)# monitor session 1