Deleting or changing an, Existing system password – Dell OptiPlex GX1 User Manual
Page 82
System Setup Options: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/setupopt.htm[2/21/2013 11:47:16 AM]
system off and then on again.
Using Your System Password to Secure Your System
Whenever you turn on your system, press the reset button, or reboot the system by pressing the
<Ctrl><Alt><Del> key combination, the following prompt appears on the screen when the Password Status
option is set to Unlocked:
Type in the password and...
— press <ENTER> to leave password security enabled.
— press <CTRL><ENTER> to disable password security.
Enter password:
If the Password Status option is set to Locked, the following prompt appears:
Type the password and press <Enter>.
After you type the correct system password and press <Enter>, your system boots and you can use the
keyboard and/or mouse to operate your system as usual.
NOTE: If you have assigned a setup password (see "
Using the Setup Password Feature
") the system
accepts your setup password as an alternate system password.
If a wrong or incomplete system password is entered, the following message appears on the screen:
** Incorrect password. **
Enter password:
If an incorrect or incomplete system password is entered again, the same message appears on the screen.
The third and subsequent times an incorrect or incomplete system password is entered, the system displays
the following message:
** Incorrect password. **
Number of unsuccessful password attempts: 3
System halted! Must power down.
The number of unsuccessful attempts made to enter the correct system password can alert you to an
unauthorized person attempting to use your system.
Even after your system is turned off and on, the previous message is displayed each time an incorrect or
incomplete system password is entered.
NOTE: You can use the Password Status option in conjunction with System Password and Setup
Password to further protect your system from unauthorized changes.
Deleting or Changing an Existing System Password
To delete or change an existing system password, perform the following steps:
1. Press the <F2> key to enter the
, and verify that the
option is