Dell PowerEdge C5125 - Manual (Page 52)

52 Installing System Components
Installing a Memory Module
The system board has four slots in two channels for the installation of
memory modules. See "C5125 System Board Components" on page 89 for the
location of the memory modules.
Follow these instructions to install memory modules:
1 Align the memory module correctly with the DIMM slot. Note the notch
and obstruction in Figure 3-4.
2 Press the edge connector of the memory module into the DIMM slot. Press
down firmly on the memory module so that the locking latches of the
DIMM slot are levered upwards to secure the memory module in place.
WARNING: The memory modules are hot to touch for some time after the system
has been powered down. Allow time for the memory modules to cool before
handling them. Handle the memory modules by the card edges and avoid touching
the components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.