Clearing cmos settings – Dell Dimension 3100/E310 User Manual
Page 47
9.
Locate the 3-pin password jumper (PSWD) on the
system board
and attach the jumper to pins 1 and 2 to reenable the password feature.
10.
Replace the
computer cover
.
11.
Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
1.
Follow the procedures in "
Before You Begin
."
2.
Reset the current CMOS settings:
a.
Locate the 3-pin CMOS jumper (RTCRST) on the system board.
b.
Remove the jumper plug from pins 2 and 3.
c.
Place the jumper plug on pins 1 and 2 and wait approximately five seconds.
d.
Replace the jumper plug on pins 2 and 3.
3.
Replace the
computer cover
.
4.
Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.