Dell PowerVault MD3000 - Manual

Dell™ PowerVault™
MD3000/MD3000i RAID Controller
Password Reset
Perform this procedure when you have lost or forgotten your password and you
need to reset it.
Connecting the Serial Cable
1 Remove the serial cable from the password reset cable package.
2 Connect the DB9 (oval) end of the cable to the serial port on the computer to
be used to communicate with the RAID Controller module.
3 Connect the PS2-type (round) end of the cable to the serial port on either of
the array’s RAID Controller Modules. The flat side of the connector faces
down when inserting.
System Setup
Microsoft
®
Windows
®
Operating Systems
1 Click Start→Programs→Accessories→Communication→HyperTerminal to
run HyperTerminal.
If HyperTerminal is not installed, click Control Panel
→Add/Remove
Programs →Add/Remove Windows Components, find HyperTerminal and
click the check-box, then click Apply and OK.
NOTE:
The original Windows installation disk may be needed to install
HyperTerminal.
NOTE:
If you are running Windows Vista
®
or Windows Server
®
2008,
HyperTerminal is not included in the operating system. To complete these steps, a
third-party terminal emulation program is required.
March 2009
52933A00.fm Page 9 Thursday, March 19, 2009 9:56 AM