Campbell Hausfeld IN727601AV - Manual

2
Attach air
hose to regulator
outlet.
Adjust
regulator knob so
outlet pressure is
between 70 psi and
120 psi.
70
psi
120
psi
1
Close pressure
regulator, Turn
ON compressor and
Allow tank to reach
maximum pressure.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
Setup Like a Pro
CHN70600 — Air Powered Angle Finish Nailer
4
2-1/2 inch 35° Finish Nailer
CHN70600
IN727601AV 6/09
Visit us at chpower.com
Setup Like a Pro
Easy Setup Guide
Projects are easier with
Campbell Hausfeld products.
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro
.
Load fasteners. See manual for further information regarding length and type of fasteners.
3
Pull pusher back
until it latches.
Load nails. Press pusher latch button and
allow pusher to ride against nails.
Nail Pusher
Latch Button
© 2009 Campbell Hausfeld/Scott Fetzer © 2009 Campbell Hausfeld/Scott Fetzer
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Battery Replacement
Screw
Attach coupler on air
hose to nailer inlet.