Chicco 430 - Manual (Page 14)

Page 1
The Big Caboose Stand-On Triple Instruction Manual
Figure 6
Folding the Stroller
• Keep children away from stroller
while folding.
• Remove any infant carrier that has
been installed on the stroller. Note
that the stroller can still be folded
with a car seat carrier support in
place.
• Position the stroller with the handle
bar closest to you.
• Place each canopy into its closed
position and push it all the way
forward toward the front of the
stroller as far as it will go.
• Make sure both rear wheel brakes
are set to their locked positions.
• Lock both front wheels in place with
the locking levers facing forward.
• To fold, unlatch the safety latch on
EACH side of the stroller.
• Pull upward on the trigger
mechanisms on both sides of the
stroller. See Figure 26.
• While these mechanisms are in the
upward position, push forward on
the stroller using the handle bar.
• Once the stroller begins to fold, push
the handle all the way forward and
down until the stroller is completely
folded. See Figure 27.
Figure 7
IMPORTANT NOTE
When using your stroller as an infant car seat carrier, the following
are the compatible infant car seat models that the Caboose Stand-On
Tandem will accommodate:
• Graco ® Snug Rider™ Series
• Graco® SafeSeat™
• Peg Perego
® Primo Viaggio
• Peg Perego® Primo Viaggio SIP
• Evenfl o
® Embrace™
• Chicco® Key Fit Car Seat
• Britax® Companion™
For the most updated list of compatible infant car seats, please
either check our website at www.joovy.com or call our Customer
Service Department at (877) 6-09.
• Combi® Centre Series
• Combi® Connection
• Safety 1st ® Designer 22™
• Eddie Bauer ® Infant Car Seat
(models 22-625 and 22-626)
• Baby Trend ® Latch-Loc and Flex-Loc
• Compass® Light and Portable Infant Car Seat