Dell Brocade Adapters - Manual (Page 31)

Brocade Adapters Troubleshooting Guide 7
53-1002145-01
How to use this chapter
2
“Installing Windows 2008 R2 DUD on UEFI system results
in offline disk” “General adapter problems”
“UEFI boot problems” Windows
2008
“Driver and operating system installation failure on boot
LUN” “General adapter problems”
“BIOS boot problems” All
“Target not visible from host” “General adapter problems”
“BIOS boot problems” Windows
“Ctlr-B option does not display when booting host” “General adapter problems”
“BIOS boot problems” Windows
“No target devices found or link down message displays in
Brocade BIOS Configuration menu” “General adapter problems”
“BIOS boot problems” Windows
“Unable to boot from the stored boot device settings in
the adapter” “General adapter problems”
“BIOS boot problems” Windows
“Remote LUNs are not visible to the host” “General adapter problems”
“BIOS boot problems” Windows
“Cannot boot over SAN from installed CNAs or Fabric
Adapters” “General adapter problems”
“BIOS boot problems” Windows
“Boot from SAN may stop on some Hewlett Packard hosts” “General adapter problems”
“BIOS boot problems”
Windows
“Adapter <port id>: BIOS not installed displays during boot
process” “General adapter problems”
“BIOS boot problems” Windows
“VLANs and teams persist after changing port to HBA
mode” “Fabric Adapter problems” Windows
“HCM not discovering all Ethernet ports for vNICs” “Fabric Adapter problems” Windows
“No adapters found on local host” message in HCM” “HBA problems” Windows
“Only one adapter port participates in trunk” “HBA problems” All
“Quality of Service performance issues” “HBA problems” All
“Quality of Service not functioning” “HBA problems” All
“Only one adapter port participates in trunk” “HBA problems”
“Trunking problems” All
“Trunked port disables on the switch” “HBA problems”
“Trunking problems” All
“Cannot disable trunking” “HBA problems”
“Trunking problems” All
“Unable to create more than 126 Virtual (NPIV) ports for
adapter” “HBA problems” All
“Cannot manage CNAs after attempting upgrade to 3.0
drivers” “CNA problems” Windows
2003
“VMQs not created for virtual network adapter instances” “CNA problems” Windows
2008
“Ethernet loopback test problems” “Network interface problems (CNA
or NIC)” All
TABLE 2 Isolate adapter problems (continued)
Problem Category OS Specific