Setting up the monitor, Attaching the stand, Connecting your monitor – Dell AW2210 Monitor User Manual
Page 26
Back to Contents Page
Setting Up the Monitor
Alienware OptX™ AW2210 User's Guide
Organizing the Cables and Attaching the Cable Cover
Attaching the Stand
Remove the monitor cover and place the monitor on it.
1.
Fit the two tabs on the upper part of the stand into the grooves on the back of the monitor.
2.
Lower the stand so that the monitor mounting area snaps onto the stand.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect your monitor to your computer using ONLY ONE of the following cables: the DVI (digital DVI-D) or the HDMI cable.
Use both the cables
only when they are connected to two different computers with appropriate video systems.
Connecting the White DVI Cable
OR
Connecting the HDMI Cable
NOTE:
The stand is detached from monitor when it is shipped from the factory.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.