Dell XPS M2010 (MXP061, Mid 2006) - Manual (Page 70)

c. Lift the card out of its connector.
5. Install the card:
a. Align the card with the connector at a 45-degree angle, and press the card into the connector until it clicks.
b. Connect the antenna cable to the antenna connector on the mini-card by matching the color of the cable to the color of the triangle above the
connector. Connect the main cable (white) to the antenna connector with the white triangle. Connect the auxiliary cable (black) to the antenna
connector with the black triangle.
6. Replace the memory cover. See Memory .
7. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
8. Turn on the computer.
Coin-Cell Battery
To remove the coin-cell battery:
1. Follow the procedures in Before You Begin .
2. Remove the memory cover. See Memory .
3. Remove the battery from the compartment on the system board by using a small screwdriver to lift one side of the battery at the notch in the plastic
connector, being careful not to break the plastic.
4. Grasp the battery and pull out it of the battery compartment.
To install the coin-cell battery:
1. Insert the edge of the coin-cell battery into the plastic battery compartment under the lip on the compartment.
2. Carefully press the coin-cell battery into the compartment, being careful not to break the plastic.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.
NOTICE: To avoid damaging the card, ensure that the antenna cable is not under the card when you click the card into place.
NOTE: If your computer has a gray cable, connect it to the connector with the gray triangle, if one is available on your card.
CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1 coin-cell battery 2 battery compartment