Raid battery, Removing a raid battery – Dell PowerVault NX3000 User Manual
Page 113
Advertising
Installing System Components
113
Figure 3-23.
Storage Controller Card Cabling (Four 3.5-inch Hard Drive Chassis)
RAID Battery
The information in this section applies only to systems with the optional
PERC controller card.
Removing a RAID Battery
1 Pull back gently on the right edge of the battery bay and draw out the
RAID battery from the battery carrier.
2 Disconnect the cable between the RAID battery and the storage controller
card. See Figure 3-24.
1
RAID battery (PERC only)
2
SAS A connector on backplane
3
cable retention bracket
4
integrated storage controller card
5
SAS_0 connector
6
RAID battery connector (PERC only)
3
2
4
1
5
6
Advertising