Cypress WPT-800-HUSB - Manual (Page 4)

HUSB Installation Manual
Doc No. 910-00003-01 Rev 05
Page 4 of 6
2.2. Powering On the HUSB
The HUSB is powered through the USB port on the WPT Green Box. To power on
the HUSB, connect the USB Cable to the WPT Green Box’s USB port. The HUSB
turns on and performs initialization. After initialization, the LCD displays either E0 or
the current channel frequency.
The various indicators and characters that are displayed on the LCD display are as
shown in the Figure 4.
Figure 4. LCD Display
The front panel of the LCD display is used to perform diagnostics on the HUSB and
no user information is displayed.
2.3. Configuring the HUSB
The HUSB is factory configured with Network ID 1. If the network ID of the WPT
system is other than 1, the HUSB must be configured with a valid network ID to make
it functional.
Note: HUSB has a blank front cover to prevent accidental changes to the
configuration settings. The front cover has to be removed to gain access to
the display and switches.
Note: The network ID is a single digit number and cannot have a “0” value.
To configure the network ID, perform the following:
1. Press and release all three buttons simultaneously. The HUSB enters
programming mode, shows the network ID and the first digit starts flashing.
The °F icon is displayed, indicating that the network I D is being programmed.
Press and release all three
buttons simultaneously to
enter Programming Mode
Digit will flash when
configuring the Network ID