Cabletron Systems 2H28-08R - Manual (Page 96)

Chapter 5: Local Management
5-48 2H28-08R SmartSwitch 2208 User’s Guide
Current Switch Utilization (Read-only)
Shows how much (percentage of processor capacity) of the 2H28-08R is
currently being used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of maximum switching capacity, since last
reset.
Reset Peak Switch Utilization (Toggle)
Allows the user to reset the Peak Switch Utilization field. Setting the
switch to YES resets the Peak Switch Utilization field.
5.13.1 Setting the Reset Peak Switch Utilization
To reset the Peak Switch Utilization field, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization
field.
2. Press the SPACE bar to toggle the selection to YES.
3. Use the arrows keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.
5.14 FLASH DOWNLOAD SCREEN
The Flash Download screen, shown in Figure 5-20 , allows the user to
upgrade the device with a different firmware image.
Before downloading an image to the device, copy the image to the
network TFTP server.
NOTE
The user may also force the download of an image by changing
the position of Switch 6 located inside the device. Refer to
Section C.2.1 , for details.
NOTE
For information about how to set up a workstation as a TFTP
server, refer to the specific workstation documentation.