ClearSounds CSC500 - Manual (Page 8)

8 – ENGLISH
Desk / Table Mounting
1. Connect one end of the 6 ft telephone cord to the line
jack on the back of the phone and connect the other end
to a modular phone jack.
2. Connect one end of the coiled handset cord to the
handset and the other end to the phone base.
3. Lift the handset and listen for the dial tone. If you don’t
hear a dial tone, re-check all the installation steps.
Wall Mounting
1.
Slide the handset hanger tab out and reverse its position
(rotate it 180 degrees). Slide it back into place so that
the hook points up. This will keep the handset from
falling out of the cradle when it is mounted on the wall.
2.
Plug the 6-inch short phone cord into the telephone
jack on the phone, run the phone cord underneath the
wall plate adapter and through the opening. The excess
telephone line can be positioned into the recessed area
on the bottom of the mounting plate.
3.
Insert the wall plate adapter by holding the wall plate
adapter so that the raised mounting pins line up with the
phone’s keyholes on the back. Once the holes are lined
up, push the wall plate adapter in towards the phone and
then slide the plate upwards until it is securely seated
on the phone
4.
With the wall plate adapter installed, plug the 6-inch
short phone cord into the jack on the wall.
Desk tab
position
Wall mount
tab position