Cisco IP/TV 3400 Series - Manual (Page 69)

3-7
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3425 and 3425A Server Units
Connecting Cables
To connect network, monitor, keyboard, and mouse cables to the Cisco IP/TV
Server, follow these steps:
Step 1 Plug the monitor cable into the onboard video port on the IP/TV Server back
panel.
Step 2 Connect the other end of the monitor cable to a monitor.
Step 3 Connect a keyboard and mouse to the keyboard port and mouse ports on the IP/TV
Server back panel.
Step 4 For network connections, insert a Category 5 UTP cable into the
Ethernet port labeled “Ethernet 0” on the IP/TV Server front panel. (See
Figure 3-7 .) When active, the System LED on the left front corner of the Cisco
IP/TV 3400 Series Server is lit.
Note The console port and Ethernet port 1 are not used by Cisco IP/TV 3400
Series Servers.
Figure 3-7 Cisco IP/TV 3425 and 3425A Servers—Front Panel Connectors
Step 5 Connect the other end of the network cable to a hub or switch in your network.
55004 CONSOLE ETHERNET 0 ETHERNET 1 SCSI LVD ONLY SLOT 0 SLOT 1
Console
(not supported in IP/TV)
Ethernet 0
Ethernet 1
(not supported in IP/TV)
SCSI LVD only
Slot 0 Slot 1