Cisco IP/TV 3400 Series - Manual (Page 70)

Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3425 and 3425A Server Units
3-8
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Connecting Power and Booting the System
To connect AC power to the IP/TV Server, follow these steps:
Step 1 Plug the AC power cord into the power cord receptacle on the back of the IP/TV
Server. (See
Figure 3-8 .)
Step 2 Connect the other end of the power cord to a power source at your installation site.
Step 3 Power on the device.
The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See
Chapter 4, “Setting IP/TV Server
Configuration Parameters.” )
Figure 3-8 Cisco IP/TV 3425 and 3425A Servers—Rear View
33192
Power switch
Power receptacle