Cisco IP/TV 3400 Series - Manual (Page 74)

Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3426 Broadcast Server Units
3-12
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Installing the Chassis in the Rack
To install the IP/TV Server in the rack, follow these steps:
Step 1 Select a 1-RU-size location in the rack. Starting with the right front side of the
rack (as viewed from the front of the IP/TV Server), install a clip nut or cage nut
in the top and bottom positions of the 1-RU location that you selected (see
Figure 3-10 ) and then install a clip nut or cage nut in the corresponding positions
on the rear of the rack.
Repeat this step for the left front side of the rack and the corresponding location
on the rear of the rack.
Figure 3-10 Installing Clip Nuts or Cage Nuts
Step 2 Remove the inner slide rails from the slide rail assemblies by pressing the release
latches on the sides of the slide rail assemblies. (See
Figure 3-11 .)
1 Cage nuts 2 Clip nuts
83200
1 2