Cisco IP/TV 3400 Series - Manual (Page 96)

Chapter 3 Installing the IP/TV Server
Connecting Cables to Video Capture Cards
3-34
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Step 2 Connect the video capture card to the appropriate video source:
• If you are using a composite video source, connect the connector marked
Composite to the video source device.
• If you are using an S-video source, connect the connector marked S-video to
the video source device.
Step 3 Connect the audio cables from the video source device to the Line/Mic audio port
(labeled 3 in
Figure 3-25 ) on the video capture card.
Optibase MovieMaker 200S Networker Video Capture Card
The Optibase MovieMaker 200S Networker video capture card has one audio and
one video capture channel.
The IP/TV Server accessory kit contains the following cables for connecting the
IP/TV Server to audio and video sources:
• Video BNC connector cable
• S-video mini-DIN cable
• Mini-jack stereo audio cable
For more details on the contents of the IP/TV Server accessory kit, see the “Server
Accessory Kits” section on page 1-24 . If any items are missing or damaged,
contact your place of purchase.
To connect the Optibase MovieMaker 200S Networker video capture card to
video and audio sources, follow these steps:
Step 1 Connect the video capture card to the appropriate video source device:
• If you are using a composite video source, plug one end of the video BNC
connector cable into the V IN port (labeled 2 in
Figure 3-26 ) on the video
capture card.
• If you are using an S-video source, plug one end of the S-video mini-DIN
cable into the S-Video port (labeled 1 in
Figure 3-26 ) in on the video
capture card.