Cisco IP/TV 3400 Series - Manual (Page 97)

3-35
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Checking the LEDs
Figure 3-26 Optibase MovieMaker 200S Networker Video Capture
Card—Connecting to the Video Source
Step 2 Connect the other end of the video BNC connector cable or the S-video mini-DIN
cable to the appropriate ports on the video source device.
Step 3 Plug the audio connector cable from the video source device to the A IN port
(labeled 5 in
Figure 3-26 ) on the video capture card.
Checking the LEDs
When the IP/TV Server is up and running, observe the front and back panel LEDs
to verify that your system is operating properly. (See
Figure 1-3 , Figure 1-7 ,
Figure 1-8 , Figure 1-11 , and Figure 1-12 , and Table 1-2 , Table 1-3 , Table 1-7 ,
Table 1-8 , Table 1-11 , and Table 1-12 .)
1 S-video port 2 Video in port
3 Video out port 4 Audio out port
5 Audio in port
96404
S-VIDEO
V IN V OUT A OUT A IN
1 2 3 4 5