Crown CM-200A - Manual (Page 10)

10
PZM Wedge (Figure 14)
• Mount a PZM microphone 6 inches from the edge of
a 2-foot square panel. Mount another PZM similarly
on another panel. Tape together the panel edges
nearest the microphones, forming a “V.” Aim the
point of the “V” at the center of the sound source.
Angle the panels about 70 degrees apart. This
assembly is called a PZM wedge. Put the wedge
where you would put a stereo mic.
Theatre, Drama,
Opera, or Musicals (Figure 15)
Recording/Reinforcement:
• Use PCC-160s on the stage floor about 1 or 2 feet
from the edge of the stage.
For more information, contact Technical Services
Department at Crown International, 1718 West
Mishawaka Road, Elkhart, IN 46517 or phone
(219)294-8200 or 1-800-342-6939. Visit our
website at www.crownaudio.com.