Mmo od de e f fu un nc cttiio on ns s – Cobra Electronics PR3850WX User Manual
Page 10
Customer Assistance
Warranty
Introduction
1
15
5
N
No
otth
hiin
ng
g Comes Close to a Cobra
®
O
Op
pe
erra
attiio
on
n
Channel Scan
••
Your microTALK
®
radio can automatically scan channels.
To scan channels:
1. Press the Mode/Lock button until the
Scan icon and the channel numbers
flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed
when scan is on. Your radio will continue to
scan all channels and stop if an incoming
transmission is detected. Your radio will
remain on that channel for 10 seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel or channel/privacy code displayed
before you entered mode functions.
During channel scan (while receiving an incoming
transmission), you can choose from the following:
a. Press and hold the Talk button to
communicate on that channel. Your radio
will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down
button to resume scanning channels.
If you press the Talk button while scanning,
but more than 10 seconds after receiving a
transmission, you will transmit on the channel
on which you last received a transmission.
This will return the radio to Standby mode.
If you do not press any button within
10 seconds after receiving a scanned
transmission, your radio will automatically
resume scanning channels.
1
14
4 E
En
ng
glliis
sh
h
M
Mo
od
de
e F
Fu
un
nc
cttiio
on
ns
s
To de-program a memory location:
1. Press the Mode/Lock button until the
Memory icon and the memory location
flash on the display.
2. Press the Channel Up or Channel Down
button to select the memory location
(0 through 9).
If a location has been programmed
before, its associated channel/privacy
code will be shown on the display.
3. Press the Enter/Hi•Low button. The channel
numbers will flash on the display.
4. Press the Channel Up or Channel Down
button to select Channel 0.
5. Choose one of the following:
a. Press the Enter/Hi•Low button to enter
the channel/privacy code in the selected
memory location and return to the
beginning of memory location options.
b. Press the Mode/Lock button to
enter the channel/privacy code in
the selected memory location and
proceed to other functions on the
channel/privacy code displayed
before you entered mode functions.
While de-programming a memory location,
if you do not press any buttons for 15 seconds,
your radio will automatically return to Standby
mode on the channel/privacy code displayed
before you entered mode functions.
O
Op
pe
erra
attiio
on
n
S
Sc
ca
an
nn
niin
ng
g C
Ch
ha
an
nn
ne
ells
s
M
Mo
od
de
e//L
Lo
oc
ck
k B
Bu
utttto
on
n
C
Ch
ha
an
nn
ne
ell B
Bu
utttto
on
ns
s
E
En
ntte
err//H
Hii••L
Lo
ow
w B
Bu
utttto
on
n
M
Me
em
mo
orry
y IIc
co
on
n
M
Mo
od
de
e//L
Lo
oc
ck
k B
Bu
utttto
on
n
C
Ch
ha
an
nn
ne
ell B
Bu
utttto
on
ns
s
C
Ch
ha
an
nn
ne
ell 0
0