Pro-Ject Audio Systems Amp Box User Manual
Page 3
© Audio Trade GmbH · Pro-Ject Amp Box · Revision 15.10.10/15.12.10
3
Technical specifications Pro-Ject Amp Box
Power output:
2 x 20W/30W at 8ohms/4ohms (both channels driven)
Frequency response:
5Hz - 20kHz (+ 0dB, - 0,5dB)
Channel separation:
> 40dB at 20kHz
Noise floor:
> -100dB (A weighted)
THD:
< 0,05% at 10W
Gain: 22dB
Pre in:
1 pair RCA/Phono sockets
Input sensitivity:
1V
Input impedance:
47kohms
Speaker connectors:
4mm ∅ banana plugs, spades connectors or naked wire
Trigger:
12V DC switching voltage
Trigger in and out:
2-pole co-axial ∅ 2,5mm jack
Outboard power supply:
20V/3A DC (peak 7A DC), suitable for your country's mains supply
Power consumption:
20V/3A DC
Dimensions W x H x D (D with sockets): 103 x 36 x 103 (122)mm
Weight: 670g
without
power
supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2007. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.