Pro-Ject Audio Systems MaiA User Manual

Page 4

Advertising

Remote control

turns the unit on or back into standby (long press), mute (short)

and

adjust the sound volume

and

select the inputs

VOL+ and CH+ confirm Bluetooth pairing
VOL- and CH- cancel Bluetooth pairing

Front panel controls

To switch on from standby or to standby

The push button on the left side of the front panel turns the unit on or back into standby. The blue LED above
the stand-by push button shows that the unit is switched on. Mute is active when LED is blinking.

Input selector

After the unit is powered on, pressing the buttons

◄

and

►

next to the LEDs inputs indicators selects

desired input.

Volume

Adjust the volume to the desired level, using the large knob on the front panel.

Connecting a headphone

Connect the headphones to the ¼“ (6,3mm



) jack socket on the front of the unit.

Bluetooth connection

Make sure the antenna is attached to its connector In 9 BT on the back panel prior using Bluetooth.
Bluetooth is active only once input 9 is selected. LED of Bluetooth input is blinking when no device is
connected. If the LED is on, active connection with Bluetooth device is established. Following procedures
refer to units from S/N E29069 and higher including previous units with implemented firmware update v1.3.
If you need a manual for units with previous serial numbers without firmware update, please contact your
local distributor.

Pairing with Android devices
Open Settings and tap on Bluetooth. Turn on Bluetooth and tap on Scan. Searched devices will show up.
Tap on "MaiA" and confirm presented pairing code on your Android device. Then press

►

(pair) button on

MaiA (alternatively CH+ or VOL+ button on remote control) when the blue LED of input 9 starts blinking.
When paired with MaiA, your Android device will show "Connected to media Audio". Now you can play
music from your Android device over Bluetooth to MaiA.

CH+

CH-

VOL+

VOL-

ON/OFF

VOL

Advertising

Popular Brands

Popular manuals