Pro-Ject Audio Systems Head Box SE II - Manual (Page 2)

© Audio Trade GmbH · Pro-Ject Head Box SE II · Revision 15.10.10/15.12.10
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO headphone amplifier. With this unit you can connect up to two
headphones to your amplifier and adjust their volume individually.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
!
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Connection to the amplifier (recorder)
Connect the TAPE OUT RCA/phono sockets from your amplifier to the In RCA/phono sockets of the
headphone amplifier. The Out RCA/phono sockets of the headphone amplifier can be connected to the input
sockets of your recorder.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left
channel black or white.
Power
~ 16V
In
Out
Right Left
Out
In
Connecting the headphones
Connect the headphones to the ¼“ jack socket marked Phones 1 or Phones 2 on the front of the
headphone amplifier. Use the Volume1 and Volume2 control knobs to adjust the level to the required
volume. Two sets of headphones may be used in parallel.
Volume 2 Volume 1 Phones 1 Phones 2 Volume 2 Volume 1 Phones 1 Phones 2
Head Box SE II
!
Turn the volume level to minimum before connecting the headphones.
Minimum impedance of the head phone / both head phones 30ohms.
Headphone replay
Use the input selector of the amplifier to choose the source you wish to hear.