Pro-Ject Audio Systems Receiver Box S - Manual (Page 4)

© Audio Trade GmbH · Pro-Ject Receiver Box S · Revision 2013.1.15
4
Auto store function
Long press
0
M4
starts,
0
M1
confirms the auto store function.
0
M1
clears the complete memory while
storing.
0
M2
keeps stations with good signal strength in the memory and overwrites stations with insufficient
signal level while storing.
Front panel controls
Receiver Box S
To switch on from standby or to standby
The push button on the left hand side will toggle the receiver between its fully operational status and standby.
The blue LED above the stand-by push button shows that the unit is switched on.
In standby the display will show STANDBY.
While switching off, the unit saves the settings for input, volume and mute, to be set automatically after next
power on.
Input selector
After the unit is powered on, the push button selects the inputs IN1, IN2 and the tuner mode in turn. The
display will show the volume level and the selected input: TUNER, IN1 or IN2.
The optional input expander Pro-Ject Switch Box S provides three more inputs. For further details please see the
user guide of the Pro-Ject Switch Box S.
Volume
and adjust the volume (95 steps) to the desired level. The display will show the volume level set.
-95dB indicates min., 00dB max..
Mute
While the unit is powered on,
0
ON/OFF
activates and deactivates mute .
Dimming the display
After pressing
0
_
VOL
or
0
+ VOL
on the remote control,
TUNE
or
TUNE
set the brightness of the display.
Available settings: DIM MIN, DIM 1 - DIM 4 and DIM MAX. The display will show the selected setting.