Pro-Ject Audio Systems Stereo Box S - Manual (Page 4)

© Audio Trade GmbH · Pro-Ject Stereo Box S – 25/37W · Revision 2014.2.1
4
Replacing batteries
Proceed as follows:
 Unlock and slide open the battery case cover
 Replace the battery.
Make sure the battery is the right way round !
 Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Stereo Box S
Power output: 2 x 25W/37W at 8 ohms/4 ohms (both channels driven)
Frequency response: 5Hz - 20kHz (+0dB, -0,5dB)
Channel separation: >65dB at 20kHz
Noise floor: >90dB (A weighted)
THD: <0,07% at 15W
Gain: 31dB
Line-level inputs:
2 pair RCA/phono sockets
Input sensitivity: 350mV
Input impedance: 50kohms
Record Out: 3-pole 3,5mm co-axial jack
Speaker connectors: 4mm  banana plugs, spades connectors or naked wire
Outboard power supply: 20V/3A DC, suitable for your country's mains supply
Power consumption: 3A DC, <1W in standby
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (122)mm
Weight:
720g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
© 2011. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.