Pro-Ject Audio Systems DAC Box RS - Manual (Page 2)

© Pro-Ject Audio Systems · Pro-Ject DAC Box RS · Revision 2014.4.1
2
Dear music lover,
thank you for purchasing a Pro-Ject Audio DAC Box RS.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all
times. Never handle the device, the power cord/power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power
supply. Never place any naked flame sources, such as lighted candles on or near the device. The product
shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar
conditions.
Tubes produce heat. Proper ventilation has to be guaranteed all the time. The unit must not be stacked.
Connectors
Make all connections, except the connection to the computer , whilst the unit is disconnected from
the power supply. Connect the unit to the mains and switch it on before connecting it to the
computer .
Take care to connect the left and right channels correctly. The right channel is usually marked red,
the left channel black or white.
Do
not connect RCA and XLR outputs simultaneously.
Wiring XLR sockets: 1 ground, 2 “hot” and 3 “cold”.
Never use any other power supply than the one supplied with the unit except of Pro-Ject Power Box.
Connection to the amplifier
Connect the Analog Out socket to a line input (such as AUX) on your amplifier.
Connecting the Pro-Ject CD Box RS
To be able to use the Sonic2 playback mode, the input In 2 Sonic AND the input Clock Out have to be
connected to the corresponding connectors on the Pro-Ject CD Box RS.
In 2 Sonic (I 2 S) and Clock Out can be used with Pro-Ject CD Box RS only.
The cable length for Sonic and Clock connection must not be longer than 29,5 inch (75cm).
!
!
!
!