Pro-Ject Audio Systems DAC Box FL - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject USB Box FL · Revision 15.10.10/15.12.10
3
Technical specifications Pro-Ject DAC Box FL
Line-level output: 1 pair RCA/Phono sockets
Output voltage: 1,9Vrms
Digital outputs: 1 x coaxial (S/PDIF)
1 x optical (TOSlink ® )
D/A converter: Philips TDA 1543 16Bit/44,1kHz (4 converter in parallel mode)
without oversampling and digital filter
Sampling rates: 32kHz, 44,1kHz, 48kHz and 96kHz
Dimensions W x H x D (D with sockets): 103 x 36 x 103 (109)mm
Weight: 560g
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2009. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
TOSlink ® is a registered trademark of Toshiba corporation.