Centro Barbecue Stainless 4000 - Manual (Page 8)

6
L I G H T I N G
T H E G R I L L
Make Sure you have followed all the safety checks, procedures and instructions
indicated in the previous section, before attempting to light the grill.
Lighting The Main Burners
1. Always open the hood completely and always inspect the grill and burners to confirm
that all components are properly positioned before lighting the main burners.
2. Always confirm that all of the burner control knobs are in the OFF position before
opening the gas supply.
3. Slowly turn on the propane gas supply valve at the tank 1-2 turns.
4. Wait approximately 5 seconds before turning the selected burner control to the
HIGH position by pushing down on the knob and turning it counter-clockwise.
This procedure allows pressure to stabilize, and prevents the flow limiting feature
from being activated.
5. Immediately turn the Rotary Ignitor knob clockwise. As you turn the ignitor you
will hear a click as the Piexo module generates an ignition spark to the burner.
Rotate the ignitor knob until the burner lights. The selected burner should light
within 5 seconds. Light the burners sequentially from left to right.
W A R N I N G
Never stand with your head directly over the Barbecue when preparing
to light the main burners, to prevent possible bodily injury.
W A R N I N G
IF THE SELECTED BURNER DOES NOT LIGHT,
immediately turn the burner control knob and cylinder valve to the OFF
position, to prevent gas buildup. Wait five minutes for the gas to
clear and then repeat the preceding starting procedure. IF the burner will
not light when using the Ignitor, follow the match lighting instructions.
[CEN 025] G50205 BBQ Manual E 11/4/05 6:54 PM Page 6