Pro-Ject Audio Systems Power Box II - Manual (Page 2)

© Audio Trade GmbH · Pro-Ject Power Box II · Revision 15.10.10/15.12.10
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO Power Box II. Power Box II allows you to distribute power to
and control units of the Pro-Ject Box family (except Amp, Amp Box Mono and Tube Box SE II) and Pro-Ject
record Players (except models with automatic cut-off) from a single power supply.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
! Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Connecting
Connect one of the four power cables supplied to the Power ~16V socket on the Pro-Ject Box to be connected.
Connect the other end of the cable to one of the Power OUT sockets of the Power Box II.
!
Make all connections whilst the Power Box II is disconnected from the power supply.
Coincident current in all outputs can not exceed 1.000mA AC.
Pro-Ject receiver, integrated amplifier, stereo/mono main amplifier, record player with
automatic switch-off, the Tube Box SE and the DAC Box USB may not be used with the Power Box.
Mains power connection
The Power Box II is supplied with a power supply suitable for your country's mains supply. Check the label
before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from
the power supply to the socket Power ~16V of the Power Box II before connecting the power supply to the mains.
Switching on and off
Pressing on of the four power switches activates and deactivates the corresponding output at the back. The
selected output is shown respectively by the lit LED.
Technical specifications Pro-Ject Power Box II
Connections: 4 x 16V/AC (Power output each outputs max. 800mA,
all outputs max. 1.000mA)
Outboard power supply: 16V/1.000mA AC, suitable for your country's mains supply
Dimensions W x H x D (D with sockets): 103 x 36 x 103 (103)mm
Weight: 545g
without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2006. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.