Pro-Ject Audio Systems Set Hifi-Airplay - Manual (Page 6)

© Audio Trade GmbH · Pro-Ject Hifi Airplay-Set · Revision 2013.4.15
6
Front panel controls - DAC Box S USB
DAC Box S USB
To switch on from standby or to standby - DAC Box S USB
The push button on the left hand side will toggle the DAC between its fully operational status and standby.
The blue LED above the stand-by push button shows that the unit is switched on.
If there is no input signal after the DAC got powered on, the unit switches through all inputs sequentially, until it
detects a signal at one of the inputs.
Input selector - DAC Box S USB
Pressing the grey button next to the three LEDs selects the digital inputs in turns. The selected input will be shown
by the corresponding LED on the DAC Box S USB.
Replacing batteries
Proceed as follows:
 Unlock and slide open the battery case cover
 Replace the battery.
Make sure the battery is the right way round !
 Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Stereo Box S
Power output: 2 x 25W/37W at 8 ohms/4 ohms (both channels driven)
Frequency response: 20Hz - 20kHz (-0,3dB, -2,5dB)
Channel separation: >65dB at 20kHz
Noise floor: >90dB (A weighted)
THD: <0,07% at 15W
Gain: 31dB
Line-level inputs:
2 pairs RCA/phono sockets
Input sensitivity: 350mV
Input impedance: 50kohms
Record Out: 3-pole 3,5mm co-axial jack
Speaker connectors: 4mm  banana plugs, spades connectors or naked wire
Outboard power supply: 20V/3A DC, suitable for your country's mains supply
Power consumption: 3A DC, <1W in standby
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (122)mm
Weight:
720g without power supply