Pro-Ject Audio Systems Pro-Ject RPM 10.1 Evolution - Manual (Page 6)

© Audio Trade GmbH · Pro-Ject RPM 10.1 Evolution · Revision 2013.2.1
6
Connection to the amplifier
The record player has gold plated female RCA phono sockets (14) so you can substitute the interconnect cables
supplied with higher quality cables such as the Pro-Ject Connect it interconnect cables for connection to the
amplifier if you wish.
Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier. Make sure that the phono
input offers correct matching and amplification for the type of cartridge used. Line inputs (such as CD, Tuner,
Tape or Video) are not suitable.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left
channel black or white. Check the manual supplied with your amplifier for relevant information. An earthing
wire may be connected to the screw terminal between the sockets if you encounter hum problems when using
the record player.
If your amplifier does not have an input suitable for phono cartridges you will require a separate phono
amplifier stage for MM or MC cartridges which is then connected between the record player and a free line
level input of the amplifier.
For detailed product information regarding Pro-Ject Audio interconnect cables and phono amplifiers please
refer to the Pro-Ject web site
www.project-audio.com .
Switching on and off
Pressing the power switch (20) alternately starts or stops the motor.
Changing replay speed
Using the accessory tool provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2).
To revert to 33 r.p.m. repeat the proceedings using the smaller step on the pulley.
When the Pro-Ject Speed Box is used speed change between 33 and 45 r.p.m. is electronic. There is
no need to move the belt manually.
For detailed product information please refer to the Pro-Ject web site
www.project-audio.com
Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!
Technical specifications PRO-JECT RPM 10.1 Evolution / Pro-Ject 10cc Evolution
Nominal speeds 33/45 r.p.m.
Speed variance ±0,5 %
Wow and flutter ±0,01 %
Signal to noise 73dB
Effective tonearm mass 8,5g
Effective tonearm length 10 " (254mm)
Overhang 16mm
Power consumption
2W
Outboard power supply 16V/500mA AC, suitable for your country's mains supply
Dimensions (W x H x D) 480 x 210 x 330mm
Weight 16,5kg
Dimensions base (W x H x D)
500 x 80 x 400mm including spikes. H without spikes 44mm
Weight base 13,5kg