Pro-Ject Audio Systems Pro-Ject Xtension 10 Evolution - Manual (Page 6)

© Audio Trade GmbH · Pro-Ject X tension 10 Evolution · Revision 2012.8.1
6
Starting the motor, Stand By
Pressing the button Speed Change will switch on the player from stand by. Press and hold the push button
Speed Change to put the unit into stand by.
Changing replay speed
The belt must be on the smaller (50Hz models) larger (60Hz models) diameter part of the motor pulley.
Press the button Speed Change to switch between 33 and 45 r.p.m.. The selected speed will be displayed
digitally.
To replay records at 78 r.p.m. perform the following steps: Remove the pulley cover. Using the tool (3a), fit
the belt (3) around the larger (50Hz models, for 60Hz models the smaller diameter has to be used) diameter
step of the pulley (2). Start the turntable by pressing the button Speed Change and switch the speed to
45 r.p.m., the platter will then revolve at 78 r.p.m.. The display still shows 45 r.p.m..
Speed Change + -
45.0
Pitch control
Repeatedly pressing the + or - buttons increases or decreases the replay speed in twenty steps of 0,1 r.p.m.
respectively. The adjusted speed is displayed digitally.
Useful tips
The base and the record player should be positioned on a low-resonance surface such as wood or multiple
layer ply board to avoid structural vibrations disturbing replay.
Technical specifications Pro-Ject X tension 10 Evolution / Pro-Ject 10cc Evolution
* Electronic speed change * 33/* 45 and 78 r.p.m.
Speed variance ±0,09 %
Wow and flutter ±0,01 %
Signal to noise 73dB
Effective tonearm mass 8,5g
Effective tonearm length 10 " (254mm)
Overhang 16mm
Power consumption
2W
Outboard power supply 16V/500mA AC, suitable for your country's mains supply
Dimensions (W x H x D) 480 x 235 x 400mm, dust cover open 480 x 495 x 535mm
Weight 18kg
Lenght Connect it connection cable 123cm
Capacity tonearm cable
65pF/meter
Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!