Pro-Ject Audio Systems Pro-Ject Measure it II User Manual
Page 2
© Audio Trade GmbH · Measure it II · Revision 15.06.11/15.07.11
Changing batteries
Proceed as follows:
Take off both battery case covers
Replace both batteries together. Make sure the batteries are the right way round
Refit the battery case covers
Battery type: 2 x AAA cells, 1,5V
If the stylus balance is not used over a long period of time the batteries should be removed.
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries
at the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Measure it II
Capacity
0 - 5g
Variance ±0,002g
Weighting modes
gram (1g = 10mN), ounce (oz), pennyweight (dwt) and carat (ct)
Display
4 digit LCD with backlight
Calibration
auto calibration using a 5g weight
Auto off
60 seconds off
Replacement battery
2 x AAA cells, 1,5V
Operating temperature
+10 - +30 C (50 - 86 degrees Fahrenheit)
Dimensions (W x H x D)
122 x 27 x 55mm
Weight 170g
What is in the box
stylus balance
calibration weight
screwdriver
2 AAA batteries
protection case for the meter
user guide
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2010. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.