ProTemp PT-05-240-GH - Manual (Page 9)

NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER SOURCE
© 2014, Pinnacle Products International, Inc. Garage Heater User’s Manual
®
Maintenance
Cleaning and Maintenance
– Before cleaning the appliance, disconnect it
from the outlet and let it cool down.
– In order to protect the enclosure, don’t
splash water onto the heater, and never
use a solvent like gasoline, isoamyl acetate,
toluene, etc. to clean the heater
– The enclosure is easy to get dirty. Wipe it
often with a soft sponge. For very dirty parts,
wipe with a sponge dipped in < 122°F water
and mild detergent, then dry the heater
enclosure with a clean cloth. Be careful not to
let the water enter the inside of the appliance.
Operation
8
Operation
Grounding Instructions
PT-03-240-GH / PT-05-240-GH:
– This heater is for use on 240 (or 208) volts.
The cord has a plug as shown in figure 2
(below). No adapter is available for this blade
configuration, and none should be used. The
type outlet is a 240 (or 208) volt grounding
outlet. When properly installed, it provides a
ground connection through the cord to the
heater to protect the operator from electric
shock.
– Be sure that the electrical receptacle is of the
configuration and capacity appropriate for the
heater.
Figure 2
NEMA L6-20P