ProTemp PT-47-TTC - Manual (Page 8)

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A FUEL SOURCE
© 2013, Pinnacle Products International, Inc. Propane Tank Top Heater User’s Manual
®
Assembly
47-TTC (Continued):
– To have all 3 burners face front, plane washer
should be to the right side of tank collar
bracket. (See Figure 6) – To have far left burner face back, plane washer
should be to the left side of tank collar bracket.
(See Figure 6)
Figure 6
&RQQHFWLQJ+HDWHUWR/3&\OLQGHU
%HVXUHWRUHDGDQGXQGHUVWDQGDOORIWKH6DIHW\
,QIRUPDWLRQLQWKLVPDQXDOEHIRUHFRQQHFWLQJ
WKHKHDWHUWRWKH/3F\OLQGHU,QVWDOODWLRQPXVW
FRQIRUPWRORFDOFRGHVDQGZLWKWKH6WDQGDUG
IRUWKH6WRUDJHDQG+DQGOLQJRI/LTXHILHG
Petroleum Gasses and ANSI/NFPA 58.
Inspect the hose and regulator prior to each use
of the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list prior to
using the heater.
Model 16-TTC:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Use a wrench to fully tighten the nut,
being careful not to over tighten.
3. Slowly open the LP cylinder valve.
Models 32-TTC / 47-TTC:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the slots in the tank collar bracket
with the tank collar ring and slide into place.
Be sure the mounting knob is to the outside,
and tighten.
3. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Use a wrench to fully tighten the nut,
being careful not to over tighten.
4. Slowly open the LP cylinder valve.
&KHFNDOOFRQQHFWLRQVIRUOHDNVXVLQJD
PL[WXUHRIGLVKVRDSDQGZDWHU$Q\
EXEEOHVDSSHDULQJVKRZDOHDN5HPRYHDQG
UHFRQQHFWWKH&RQQHFWRU1XWWRWKHYDOYH.
'2127GLUHFWWKHKHDWHU
GLVFKDUJHWRZDUGVDQ\
SURSDQHF\OLQGHUORFDWHGZLWKLQIHHWRI
the heater.
WARNING
7