Pro-Tools HMP-200 - Manual (Page 4)

HMP-200 BENDER
DIE INSTALL
WHEN USING THE DEGREE INDICATOR
IT WILL BE NECESSARY TO JACK THE HYDRAULIC
JACK UNTIL ALL SLACK IS TAKEN OUT OF THE DIE SET.
AT THIS POINT, SET THE INDICATOR AT ZERO. YOU
CAN NOW BEND THE TUBE ACCURATELY TO ANY
DEGREE.
REMEMBER THERE IS ALWAYS “SPRING BACK” ON
TUBING SO IT IS NECESSARY TO BEND PAST THE
POINT THAT YOU ACTUALLY DESIRE TO ALLOW FOR
THIS. WE SUGGEST USING A TEST PIECE OF TUBING
TO DETERMINE THE AMOUNT OF “SPRING BACK” FOR
EACH TUBING SIZE, BEFORE STARTING THE JOB.
REMEMBER TO GREASE PIVOT
PIVOT
SNUG BOLT SO
TUBING DOES NOT
MOVE.
DEGREE
INDICATOR
813-986-9000 Pro-Tools PAGE 4
STEEL DIE
ALUMINUM BAR
LINE BAR & DIE UP
EDGE TO EDGE.