Pro-Tools HB-302 One Shot - Manual (Page 15)

FAQ’s
QUALITY PRODUCTS MADE BY PEOPLE WHO CARE PRO-TOOLS (813) 986-9000
PAGE 15
Q: HOW MUCH CAN THE HB-302 BEND A TUBE.
A: THE HMP-200 CAN ONLY GO TO 90 DEGREES.
Q: IS THE BENDER PORTABLE.
A: YES IT CAN BE MOUNTED ON OUR STANDS OR ON ANY ROLLING TABLE.
Q: WHAT IS THE MAXIMUM DIAMETER THIS BENDER WILL DO?
A: THIS BENDER WILL BEND UP TO 2” O.D. ROUND TUBE OR 1.5” SQ.
Q: HOW MANY DEGREES CAN I BEND?
A: YOU CAN BEND UP TO 110 DEGREES MAX. AFTER SPRING BACK.
Q: WHAT TYPE OF MATERIAL CAN I BEND?
A: YOU CAN BEND ALUMINUM, STAINLESS STEEL, DOM, 4130 CHROME MOLY TO
NAME A FEW. CONTACT OUR SALES DEPARTMENT FOR SPECIFICS.
Q: CAN THIS BENDER USE OTHER PRO-TOOLS DIES?
A: NO IT CAN NOT. EACH BENDER IS DESIGNED TO USE ITS OWN DIES TO ENSURE
THE POSSIBLE BEND.
Q: CAN I USE ELECTRIC INSTEAD OF AIR FOR THE HYDRAULICS.
A: YES YOU CAN CONVERT TO AN ELECTRIC PUMP IF YOU WISH.
Q: HOW DO I MAKE REPEAT BENDS WITH THIS BENDER?
A: THERE ARE TWO WAYS TO DO THIS. 1) CONTACT OUR SALES DEPARTMENT AND
ORDER AN AIR CUTOFF SWITCH WHICH WILL ALLOW FOR CONSISTENT REPEAT
BENDS. 2) MAKE THE BEND YOU WANT AND BEFORE RELEASING THE TUBE. MOVE
THE COLLAR ON THE GUIDE BAR TO UNTIL IT IS NEXT TO THE BLOCK. THISIS A
VISUAL REFERENCE.