RadioPopper PX - Manual (Page 8)

RadioPopper PX Radio Wireless System
Page 14
Menu Quick Reference
Page 15
Operation: RadioPopper PX Transmitter - QUICK REFERENCE
Power On / Off - Press and hold the Power Button for one second. Green LED on indicates “power on”, Green LED off
indicates “power off”.
Enter Menu Mode - Tap the “X” button one time to enter Menu Mode. Once in Menu Mode, you will move to the
next menu each time the “P” button is pressed, and you will adjust the setting of the current menu by pressing the “X”
button.
IMPORTANT NOTE!!! When in Menu Mode, the radio will not be active for normal operation. If you attempt to
activate the system by taking a shot on your camera while in Menu Mode, the PX Transmitter will not send any radio
signals. Similarly, the PX Receiver will not receive or respond to any radio signals while in Menu Mode. Taking a shot
while in Menu Mode on the PX Transmitter will cause the menu to cycle off. All settings will be saved, and the radio
will automatically resume normal operation. The PX Receiver will NOT automatically exit the menu.
Indicator Lights - Your PX Transmitter and PX Receiver units provide various feedback and status information via the
Power LED (Green) and Link LED (Yellow).
Solid Green LED - Unit is powered on. This LED will blink momentarily during the activation of each shot.
Slow Blinking Green LED - This is an indication that your batteries are extremely low such that the PX unit can no
longer operate. The unit will power down. You may observe this auto power down at battery meter levels of 2 or less.
Strobing Yellow LED - The unit strobes the yellow Link light after the radio sends or receives each successful shot. This
strobing is also an indication that the internal computer has received the expected status signals from the internal
radio circuitry. The unit is properly reset after power-up, after leaving the Menu Mode, or after a successful shot.
NOTE: The strobing yellow LED confirmation following each shot is DISABLED in Feedback Mode 2.
X
X
X
X
P
X
P
P
P
b = Battery Level (9-1) Quickly Exit Menu
CH = Radio Chan (01-16) 1st Press: Show Current (no change); Subsequent: Cycle Channels
X G1 = Group 1 Level (00-32) 1st Press: Show Current (no change); Subsequent: Adjust Level
Reduce level by pressing the “P” button while holding “X” button.
P
X G2 = Group 2 Level (00-32) 1st Press: Show Current (no change); Subsequent: Adjust Level
Reduce level by pressing the “P” button while holding “X” button. P
P
X G3 = Group 3 Level (00-32) 1st Press: Show Current (no change); Subsequent: Adjust Level
Reduce level by pressing the “P” button while holding “X” button.
L = Light Bright Level (1-5) Cycle Levels - See result in Power light brightness
X
P
H = Hardware Mode (C, n) Cycle Hardware Brand Mode - “C” = Canon Gear, “n” = Nikon Gear
F = Feedback Mode (1-3)
Exit Menu - Resume Normal Operation
P r E = Reset Defaults
Enter Menu
Cycle - 1=Normal (strobe light on shot); 2=High Speed (no light)
X Hold 5 Sec Resets factory default settings. Displays firmware version on startup.
PX Transmitter Menu Quick Reference