RadioPopper Nano - Manual (Page 2)

8
9
10
Receiver Auto Power Off
Your Nano receiver senses when it is
attached to a flash or studio strobe. If there
is nothing attached (or turned on) for more
than five minutes, the Nano receiver will
automatically power down. Once it again
senses an attached flash or studio light, the
Nano receiver will automatically power up
and resume normal operation.
Support
Specifications
We love and support our customers.
Contact us anytime if you have any
questions.
www.radiopopper.com
[email protected]
360-713-0776
Battery (Tx and Rx):
One “CR123” Size Battery, 3.0v. Rechargeable approved.
Battery Life:
Transmitter: 150 - 300 hours continual running time.
Receiver: 75 - 100 hours continual running time.
(Depending on battery type and quality)
Radio Frequency:
902-928 MHz, ISM Band
Radio Range:
Up to 1750 ft depending on conditions and environment.
Maximum Sync Speed:
1/500 for cameras having leaf shutters.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
This equipment has been verified to comply with the limits for a class B
computing device, pursuant to FCC Rules. Operation with non-approved
equipment is likely to result in interference to radio and TV reception. The user
is cautioned that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to operate this
equipment.
Important Note: To comply with FCC RF exposure compliance requirements,
the following antenna installation and device operating configurations
must be satisfied - This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or transmitter.
INDUSTRY CANADA INFORMATION
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
FCC ID: V4TNT2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired operation.