RadioPopper Einstein Receiver - Manual

Thank you for purchasing the RP Einstein
Receiver. It’s easy to setup and use. Insert the
module in the top of the E640 light and config-
ure from the display on your E640 as follows.
The Einstein Receiver will trigger from any RP
transmitter, but requires the Jr2 Transmitter to
adjust power levels of the E640.
The RP Einstein Receiver requires no batteries,
and is configured using the display on your E640
light. Press the “FUNCTION” button on the E640,
tab down to the boxes in the lower right to set
the radio channel and group (it’s called a “Zone”
on the E640. Zones A, B, C, D on the E640
correspond to RP Groups 1, 2, 3, 4).
If you only need 3 groups:
If you will be using between one and three
lighting groups, on the display of your E640
light, use the “C-TL” channels 1 through 16 to set
the radio channel. Zones A, B, C on the E640
correspond to RP groups 1, 2, 3 on your Jr2
transmitter. Easy. :-)
If you need 4 groups:
If you’d like to use 4 groups in your setup, it’s a
bit more complicated. You’ll need to set the
radio channel on your E640 between 16 and 32
to cause the “D” zone to become enabled on the
E640 light. These channels 16 to 32 actually map
to the RadioPopper channels 1 to 16. (E640
chan 16 is actually RP channel 1, E640 chan 17 is
actually RP chan 2, etc).
Need more help?
[email protected]
360-713-0776