Before you begin installation – RearviewSafety RVS-776618 User Manual
Page 5
5
before
you
begin
installation
Step 1
Choose the monitor and camera locations.
Step 2
Install all cables in vehicle, when necessary a 0.8 (20mm) hole should be drilled
for passing camera cable through vehicles walls. Install split grommets where applicable
Step 3
Once all cables and wiring have been properly placed routed, perform a system
function test by temporarily connecting the system. If the system seems to not be operating
properly see troubleshooting
Before drilling please check that no cable or wiring is on the other side of the wall.
Please clamp all wires securely to reduce the possibility of them being damaged
while vehicle is in use. Keep all cables away from hot or moving parts and electrical
noisy components.
We recommend doing a benchmark test before installation to insure that all
components are working properly.