RearviewSafety RVS-916619P - Manual

Rear View Safety, Inc. ● 1680 Atlantic Ave #301 ● Brooklyn, NY 11213 ● Phone 800-764-1028
www.rearviewsafety.com – [email protected]
Rear View Safety Pro Tips for Sprinter Chassis third brake light camera instillation:
1. Always use our supplied camera cable from the rear to the monitor
2. You will find clean power hook-ups under the driver seat area to power our RVS
monitor offerings. Determine positive and negative hook-ups are correct
3. Our multiplex box can accept (2) more cameras and has default wires for turn
signals if required. Under the driver seat is the best place for the left and right turn signal
default hook up
4. There are two approved locations to pick up the reverse wire.
A. The BEST place to tap the reverse trigger is located in the rear of the coach in the
rear pillar at the bottom grey plastic cover. There is a 4 pin connection for the tail
lights. Strip off a little insulation of the reverse wire, attach a reverse wire, then loom
that reverse wire along our camera cable to the multiplex box
B. If you are not using our monitor with multiplex box, you can open the hood of
the Sprinter, take the cover off the fuse block and get the reverse trigger off the blue
wire.
5. Depending on your monitor choice; clip on 7 inch rear mirror monitor, 7 inch
windshield button mount “windshield button provided” or our std 7 inch stand alone
monitor, mount the monitor and then install the multiplex box either under the driver
seat or above behind the driver seat on the wall ceiling area
6. If you are using a dbl din dash mount monitor, determine what impedance that
monitor has. Std is 75, but a few monitors have a 70 impedance. We can supply a cocoon
RCA adaptor for a 70 impedance monitor. We also can supply a RCA adaptor to go into
any dbl din dash monitor. Be advised that Gentex monitors only put out 6 volts and our
cameras require 12 volts for proper operation
7. Remove the OEM third brake light and use our supplied plug and play “splice”
connection for power to the third brake light LED’s
8. Attach the camera cable to our third brake light camera connection and by using
the factory screws, place it into the now empty area with our supplied gasket