Crimestopper Security Products RS-850 - Manual (Page 11)

TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4
different transmitter codes.
1. Open Hood. (Ground Gray wire.)
2. Turn key to the ON position.
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a 2
nd
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3 rd code and
lights will flash 4 times for 4 th code. If all 4 codes are learned, the unit will automatically exit code learning mode,
otherwise turn key OFF and close hood.
2-VEHICLE OPERATION
The RS-850 system can be used for 2 car operation. A single RS-850 remote can
control two independent vehicles with RS-850 systems installed.
CAR I
CAR II
Slide
CAR I / CAR II OPERATION
START
SETUP:
1. Using the switch on the side of the remote set your controller to Car II.
2. At Car II: Simply follow the transmitter programming steps listed in the
section above. Learn YOUR remote, along with Car 2’s existing remotes.
11