Roadi RDT40 - Manual (Page 14)

OWNER S MANUAL
,
OBD2 CODE READER
14
P0101
01/04
P0005 PD
01/05
Menu:
2. ERASE
If the code retrieved is a pending code, a "
PD"”will show on the LCD
display in the end.
To view previous codes, press the
SCROLL button to scroll through to
the end, and then start from the first of the list.
9) Look up part 5 for Diagnostic Trouble Code Definitions. Match the
retrieved DTC(S) with those listed and read the definitions.
4.2 Erasing Codes:
CAUTION: Erasing the Diagnostic Trouble Codes allows the Scan Tool to
delete not only the codes from the vehicle's on-board computer, but also
"Freeze Frame" data and manufacturer specific enhanced data. Further,
the I/M Readiness Monitor Status for all vehicle Monitors is reset to "Not
Ready" or "Not Complete" status. Do not erase the codes before the
system has been checked completely by a technician.
1) If you decide to erase the DTCs, Select
"2. ERASE" from the main
menu by pressing the
ENTER button.
If the Scan Tool is not connected or no communication is established with
the vehicle yet, then refer to "Reading Codes"”from 1 to 6. at Paragraph 4.1.
stored will appear on the second line. To view additional codes, press
the SCROLL button to scroll, as necessary, until all the codes have been
shown up.