Strand class ii tuck-bury end-for-end splice, 4a 4 b – Samson 12-STRAND Class II Tuck-Bury End-for-End Splice User Manual
Page 2
PAGE 2 OF 3
SamsonRope.com
| Tel
+1.360.384.4669
12-Strand Class II Tuck-Bury End-For-End Splice
S A M S O N S P L I C I N G I N S T R U C T I O N S
s
z
Bury the remaining braided strands down the center of the rope,
entering at Mark 1 and exiting at Mark 2. The tail should enter
the standing part of the rope at the same point where the 3
loose strands passed through. Pull the tail out at Mark 2.
Route the remaining 3 strands from
the entry point to their exit points.
Repeat Steps 4, 4A, and 4B on the
opposite end of the rope.
4
A
4
B
z
s
s
z
mark 2
mark 1
mark 1
mark 2
s
z
s
z
z
s
mark 1
mark 1
mark 2
fid
mark 2
s
z
s
z
z
s
s
z
s
z
s
z
5
step
ta p e r i n g t h e ta i l s
At the end of the tapered tail, remove the fid and any tape at
the end of the tail. From the end of the tail, mark 3 consecutive
strands, as shown. Pull them out of the braid and cut off
close to the body of the rope.
Pull out marked strands and cut off
Mark 3 consecutive strands
s
z
z
mark 2
mark 1
mark 1
s
z
z
s
z
s
s
z
s
mark 2
Smooth rope
Smooth rope
Remove the tape from the end of the tails. Now smooth the
rope from the crossover toward Mark 2 to bury the tails.
5
B
Rope B
Rope A
s
z
z
mark 2
mark 1
mark 1
s
z
z
s
z
s
s
z
s
mark 2