Schiit Gungnir - Manual (Page 5)

NO USER SERVICEABLE PARTS INSIDE
balanced DAC
fully upgradable
ADAPTICLOCk ™
discrete analog
bal OUT sE OUTs digital inputs
caution: risk of electric
shock — do not open.
no user serviceable
parts inside
SCH06J
000001
230VAC 20W
2 XLR Balanced
Outputs. If the rest of
your gear is balanced,
use XLR cables to
connect Gungnir to
their inputs from these
outputs.
3 BNC Input. If you have
a source with a BNC
digital output, Gungnir
provides a true 75 ohm
BNC input for highest-
quality data transmission.
Connect this input with a
true 75-ohm BNC cable.
1 RCA Single-Ended
Outputs. If you don’t
have balanced con-
nections, use these to
connect to your amp or
preamp. We’ve provided
two pairs for your
convenience. There’s
no difference between
them.
BACK PANEL
4 Coaxial Input.
Connect your coaxial
output source with . . .
wait for it . . . a coaxial
cable! Very exciting.
5 Optical Input. Use a
standard Toslink cable
to connect to the optical
input. If you’re using an
Apple computer with
integrated optical output,
you’ll need a Toslink with
a 1/8” (3.5mm) plug on
one side, and a standard
Toslink on the other. 6 USB Input. Or not. If
you don’t have the USB
card installed, this input
will be covered. If you
do, use a standard USB
A-B cable to connect.
7 Power Switch. Up
is on. Down is off. It
doesn’t go sideways.
1 2 3 4 5
8 AC Input. Plug the
power cord in here. Plug
the other end into a wall
outlet of the correct volt-
age. Trying to run a 115V
unit on 230V will result in
a blown fuse, no music,
and a void warranty.
6
7
8