Scilogex Unoverse Peristaltic Pump Dispense 9100 - Manual (Page 6)

3. The Control Panel
The keys on the control panel are assigned with functions to calibrate the
pump, set the volume to be dispensed, set speed and ‘interval of dispense’.
Some of the keys must be operated in pairs to enter certain functions. In such
cases, the keys should be activated in the following sequence :
VOLUME+UP ....................................................................... Increase volume
VOLUME+DOWN ............................................................... Decrease volume
START ..................................................................... Start dispense operation
VOLUME+START ..........................................................Continuous dispense
STOP ............................................................... Stop dispense (‘panic button’)
SPEED+UP ....................................... Increase dispense speed to max (255)
SPEED+DOWN ........................ Decrease dispense speed (from 255 to 180)
INTERVALS(X1) ................................................. Set interval time in seconds
INTERVALS (X2) .................................................... Set number of dispenses
STOP+INTERVALS ............................ Stop & cancel interval dispense mode
CAL+START ........................................................................... Set default 200
CAL+UP ......................................................... Increase the calibrated volume
CAL+DOWN ................................................ Decrease the calibrated volume
CAL+RANGE ........................................................... Moves the decimal point
Page 5
Power socket for 12V DC 0.3A
4. Preparing the pump for use
Plug the supplied PSU into your power socket and the low voltage plug into the
socket on the left side of the unit, switch it on by pressing the ‘ON’ button. The
green LED will illuminate indicating that the unit is operational.
The display will temporarily read ‘9100’ and then default to the value 1.000 . This
value is the factory setting.
Note the direction of flow. The pump is reversible using the slide switch, so you can
return any unused reagent back into the reservoir.
Page 4
Pump direction slide switch:
Front = Lower tube ‘IN’ + Upper tube ‘OUT’
Back= Lower tube ‘OUT’ + Upper tube ‘IN’
Remote pulse such as foot switch
(Accessory) or pulse from a robotic processor
Accepts 2.5mm mono plug
On/Off switch
Power ‘ON’ indicator