Scilogex SK-D3309-Pro - Manual (Page 10)

6
Rocking Shaker & 3D Shaker
6. Faults
• When switched ON, the instrument does not work.
„ Check whether the power cable is connected.
„ Check whether the fuse is broken.
• Shaking function suddenly stop.
„ LCD displays “Er 03”, indicate the current failure
is “overload protection”.
„ Pressing the speed control knob or timer control
knob first to close shaking function, and then
restart shaking function after lowered load. If
shaking function cannot start, then repeat the
process and gradually reduce load.
7. Maintenance and Cleaning
• Proper maintenance can keep instrument working
properly and lengthen its lifetime.
• Do not spray cleanser into the instrument when
cleaning.
• Do not remove the power line when cleaning. Only
use recommended cleansers:
Dyes Isopropyl alcohol
Construction
materials
Water containing tenside /
Isopropyl alcohol
Cosmetics Water containing tenside /
Isopropyl alcohol
Foodstuffs Water containing tenside
Fuels Water containing tenside
• Before using other method for cleaning or
decontamination, the user must ascertain with the
manufacturer that this method will not damage the
instrument. Wear the proper protective gloves during
cleaning of the instrument.
Note:
• Electronic device cannot clean with cleanser.
• If you require maintenance service, must be
cleaned the instrument in advance to avoid
pollution of hazardous substances, and to
send back into original packing.
• If the instrument will not use for a long time,
please switch off and place in a dry, clean,
room temperature and stable location.